| 1 |
|
The clamp plate is CNC punched and formed heavy gauge steel with multiple clamp position holes. |
|
| 2 |
|
All mortise & tenon workpieces are held securely with 3" capacity twist action F-Clamps. |
|
| 3 |
|
The clamp plate can be tilted up to 30° with a positive stop at 90°. |
|
| 4 |
|
Tenon workpieces are positioned against the steel sidestop fence. The sidestop fence has a positive stop at 90° and can be set at any angle up to 45° to the left or right. |
|
| 5 |
|
The sidestop fence is angled left or right for simple angle joints. Similarly, the clamp plate can be tilted up to create a simple angle. An angled sidestop combined with a clamp plate tilt produces a compound angle joint. |
|
| 6 |
|
The jig table is CNC punched and formed heavy gauge steel. |
|
| 7 |
|
The table moves on its X and Y axis and is held in position with two table position lock knobs. |
|
| 8 |
|
A removable sight is used to center the jig table over the workpiece. The sight has an embedded magnet and can be stored on the side of the jig body. |
|
| 9 |
|
Table limit stops can be set for precise repositioning of the table and perfect joint repeatability. |
|
| 10 |
|
Twenty one joint guides snap easily into the joint guide track. |
|
| 11 |
|
Guides and tracks are made with indestructible Delrin plastic for smooth routing. |
|
| 12 |
|
The heavy gauge steel sub-base can accommodate almost any plunge router with its multi-position mounting system. |
|
| 13 |
|
Tapered brass guide pins track laterally in the right guide track and in or around a joint guide on the left. Fine adjustments for joint fit (i.e .001") are made by adjusting the left guide pin up and down. |
