| 1 |
|
The aluminum clamp plate is CNC machined with a non slip non marring textured surface |
|
| 2 |
|
Two powerful 3" cam action speed clamps provide amazing holding power for mortise and tenon workpieces |
|
| 3 |
|
Two powerful 3" cam action speed clamps provide amazing holding power for mortise and tenon workpieces |
|
| 4 |
|
An aluminum side stop fence has a positive 90° stop and can be angled up to 45° in either direction |
|
| 5 |
|
The 1-3/8" dust collection port can be stepped up to 2-1/2" or stepped down to 1" with the two included adaptors |
|
| 6 |
|
The table is made from Mic6® aluminum and the channels and recesses are CNC machined to exacting standards |
|
| 7 |
|
The table moves side to side, front to back and locks in place with the flip of the clamp lever |
|
| 8 |
|
A retractable sight is used to centre the table over the work piece layout marks |
|
| 9 |
|
Table limit stops can be set for precise repositioning of the table |
|
| 10 |
|
21 different joint guides snap easily into the table
|
|
| 11 |
|
Guides and track are made from Delrin plastic for smooth router movement |
|
| 12 |
|
The router sub base is CNC machined aluminum
|
|
| 13 |
|
The stainless steel tapered guide pins track laterally on the right and in or around a guide on the left.
Fine adjustments for joint fit i.e .001", are made with the left guide pin. |
|
| 14 |
|
Teflon bearing pads make routing very smooth |
|
| 15 |
|
The FMT sub base accepts almost any plunge router on the market |
